28
Network setting
Gateway:
Using [
•
], select numerals and period, press [ENTER], select [Run] and
press [ENTER].
• This is a relay point to connect two networks.
• It is necessary to specify this address when you are to connect to network of
different segments or to the Internet in the infrastructure mode or the 802.11 ad
hoc (peer-to-peer) mode. Consult the network administrator.
Mode:
Switching between 802.11 ad hoc and infrastructure using [
]
• To use 802.11 ad hoc (peer-to-peer) mode : Select 802.11 ad hoc for setting.
• To use an access point (AP) : Select infrastructure for setting.
SSID:
Use [
•
] to select characters, press [ENTER], select [Run] and press
[ENTER].
• If infrastructure is selected in communicate mode, use the SSID set for the
access point, or the same string as the ESSID.
• If 802.11 ad hoc is selected in communicate mode, use the SSID set for the
personal computer to which it is going to be connected, or the same string as
the ESSID.
• Use up to 32 alphanumeric characters for the projector SSID. If any SSID that
cannot be set for the projector has been set for the access point, consult the
network administrator, and change the SSID to some other code that can be set
for the projector.
Channel:
This cannot be set. In the 802.11 ad hoc mode and infrastructure mode, the
channel is set automatically.
WEP (encryption key size):
Switching among 64 bits, 128 bits and OFF using [
]
• Select the size of the key necessary for encryption communication.
• The size should be consistent with the settings of the personal computer and
the access point. Incidentally, 64 bits and 128 bits may sometimes be indicated
by 40 bits and 104 bits, respectively.
Key ID (encryption key ID):
Switching among KEY1 to KEY4
• Select an ID for the encryption key used. The ID should be consistent with the
settings of the personal computer and the access point.
• This specifies which one out of KEY1 to KEY4 to use for encryption.
