ENGLISH -
61
Settings
Setting
Lamp power
This function allows you to change brightness of the
screen.
Press ▲▼ to select [Lamp power] and
1 )
then press the <SELECT> button.
Press ▲▼ to select one among the
2 )
modes as below.
You can also press the <LAMP> button to
z
display [Lamp power].
Auto
Brightness according to the
input signal.
Normal
The lamp power output is
maximum.
Eco1
The lamp power output is 70%
of the Normal mode.
Eco2
The lamp power output is 53%
of the Normal mode.
Remote control
This switching function prevents remote control
interference when operating several projectors or
video equipment at the same time.
Press ▲▼ to select [Remote control].
1 )
Press ► or the <SELECT> button.
2 )
Press ▲▼ to select one among the
3 )
seven codes.
This projector provides 7 different remote
z
control codes: [ALL], [Code 1]~[Code 6].
Attention
When operating the projector under [ALL] code, you can
z
operate several projectors at the same time. If you want
to operate the projector independently, you must switch
to other code.
When different codes are set on the projector and on the
z
remote control, any operation cannot be made. In that
case, switch the code on the remote control to fit the
code on the projector.
Security
This function allows you to use the Key lock and PIN
code lock function to set the security for the projector
operation.
Press ▲▼ to select [Security].
1 )
Press ► or the <SELECT> button to
2 )
access the submenu.
Key lock
J
This function locks the control panel and remote
control buttons to prevent operation by unauthorized
persons.
Press ▲▼ to select the desired items
1 )
as below.
Unlocked.
Lock the operation of the control
panel. To unlock, use the remote
control.
Lock the operation of the remote
control. To unlock, use the control
panel.
PIN code lock
J
This function prevents the projector from being
operated by unauthorized persons and provides the
following setting options for security.
Press ▲▼ to select the desired items
1 )
as below.
Off
Unlocked.
On1
Enter the PIN code every time
turning on the projector.
On2
Enter the PIN code to operate
the projector once the power cord
is disconnected; as long as the
AC power cord is connected, the
projector can be operated without
a PIN code.
Attention
You can enter a PIN code through the control panel or
z
the remote control. For details, please refer to "Enter a
PIN code" (
Æ
page 32).
Whenever you change the [PIN code lock] setting or the
z
[PIN code] (the four-digit number), you are required to
enter the [PIN code]. The "1234" is set as the initial [PIN
code] at the factory.