ENGLISH - 123
Control commands via LAN
You can also control via the <LAN> terminal by using the control command format via the <SERIAL IN> terminal.
For examples of the available commands, refer to “Control commands” (
x
page
128
).
Attention
f
Set the password of administrator account before using the LAN control. (
x
pages 39, 83)
When web control administrator rights password is set (Protect mode)
Connection method
1) Obtain the IP address and port number (Initial set value = 1 024) of the projector and make a request
for connection to the projector.
f
Acquire the IP address from the menu screen of the projector, and the port number from the web control
page.
IP address
Obtain from the [NETWORK] menu → [NETWORK STATUS]
Port No.
Obtain from [Detailed set up] → [Port set up] page of the web control
2) Check the response from the projector.
Data section
Blank
Mode
Blank
Random number section
Termination symbol
Command
example
“NTCONTROL”
(ASCII string)
‘ ’
0x20
‘1’
0x31
‘ ’
0x20
“zzzzzzzz”
(ASCII code hexadecimal
number)
(CR)
0x0d
Data length
9 bytes
1 byte
1 byte
1 byte
8 bytes
1 byte
f
Mode : 1 = Protect mode
f
Example: Response during protect mode (random number section is undefined value)
“NTCONTROL 1 23181e1e” (CR)
3) Generate a 32-byte hash value from the following data using MD5 algorithm.
f
“xxxxxx:yyyyy:zzzzzzzz”
xxxxxx :
Administrator rights user name for web control (Default user name is “dispadmin”)
yyyyy :
Password of above administrator rights user
zzzzzzzz :
8-byte random number obtained in Step
2)
Command data format
It is the data format used for sending and receiving commands.
r
Transmitted data
Header
Data section
Termination symbol
Command
example
Hash value
(See above
"Connection method")
‘0’
0x30
‘0’
0x30
Control command
(ASCII string)
(CR)
0x0d
Data length
32 bytes
1 byte
1 byte
Undefined length
1 byte
f
Example: Transmission of power supply status acquisition command (hash value is calculated from default user
name, password, and acquired random number)
“dbdd2dabd3d4d68c5dd970ec0c29fa6400QPW” (CR)
r
Received data
Header
Data section
Termination symbol
Command
example
‘0’
0x30
‘0’
0x30
Control command
(ASCII string)
(CR)
0x0d
Data length
1 byte
1 byte
Undefined length
1 byte
f
Example: The projector is powered on
“00001” (CR)
Chapter 7 Appendix - Technical Information
