Chapter 3
Basic Operations — Switching on/off the projector
ENGLISH - 63
f
To set the projector based on luminance
Luminance (lm)
When [CONSTANT MODE] is set to [OFF]
When [CONSTANT MODE] is set to [AUTO] or [PC]
[MAX LIGHT
OUTPUT LEVEL]
(%)
[LIGHT OUTPUT]
(%)
Runtime (hour)
[MAX LIGHT
OUTPUT LEVEL]
(%)
[LIGHT OUTPUT]
(%)
Runtime (hour)
10 000
100.0
100.0
20 000
―
―
―
9 000
100.0
90.0
22 500
―
―
―
8 000
100.0
80.0
24 500
100.0
80.0
5 000
7 000
100.0
70.0
27 000
100.0
70.0
10 000
6 000
100.0
60.0
29 500
100.0
60.0
16 000
5 000
100.0
50.0
31 500
100.0
50.0
22 000
4 000
100.0
40.0
33 500
100.0
40.0
30 500
3 000
100.0
30.0
36 000
100.0
30.0
44 500
Note
f
The runtime may be shorter than the estimation due to the influence of characteristics of each light source, conditions of use, installation
environment, etc.
f
The duration of use is referred to as the runtime when you use the projector successively. The duration of use is an estimated duration and
is not the warranty period.
f
If the runtime exceeds 20 000 hours, replacement of the components inside the projector may be required. Consult your dealer for details.
Initial setting (installation setting)
Set [FRONT/REAR] and [FLOOR/CEILING] in [PROJECTION METHOD] depending on the installation mode.
Refer to “Installation mode” (
x
page 32) for details.
After completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu
→
[PROJECTION METHOD].
1) Press
qw
to switch the setting.
3/7
ENTER
SET
CHANGE
Change the projection method (FRONT/REAR,
FLOOR/CEILING) if the screen display is upside down
or inverted.
PROJECTION METHOD
INITIAL SETTING
FRONT/REAR
FLOOR/CEILING
MENU SELECT
FRONT
AUTO
2) Press the <ENTER> button to proceed to the initial setting.
