Chapter 3
Basic Operations — Switching on/off the projector
ENGLISH - 61
Operation
Adjustment
Range of adjustment
Press
w
.
Increases the maximum level of brightness correction.
8.0 % - 100.0 %
Press
q
.
Decreases the maximum level of brightness correction.
5) Press
as
to select [LIGHT OUTPUT].
6) Press
qw
to adjust.
Operation
Adjustment
Range of adjustment
Brightness
Runtime (estimate)
Press
w
.
The screen becomes brighter.
The runtime becomes shorter.
8.0 % - 100.0 %
Press
q
.
The screen becomes darker.
The runtime becomes longer.
7) Press
as
to select [CONSTANT MODE].
8) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[OFF]
Does not perform the brightness control (correction by the brightness sensor).
[AUTO]
Performs the brightness control (correction by the brightness sensor).
When the brightness of light source or white balance changes, the brightness of the screen is
automatically corrected.
[PC]
Synchronizes nine or more projectors using a computer and the dedicated software “Multi Monitoring
& Control Software”
*1
.
*1
“Multi Monitoring & Control Software” can be downloaded from the Panasonic website (https://panasonic.net/cns/projector/).
f
Proceed to Step
15)
if the brightness control is not to be performed (when [OFF] is selected).
f
Proceed to Step
11)
when [PC] is selected.
9) Press
as
to select [LINK].
10) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[OFF]
Performs correction by the brightness sensor on one projector without synchronizing with the other
projectors.
The duration that the constant brightness is kept will become longer by setting the value of [LIGHT
OUTPUT] smaller.
[GROUP A]
[GROUP B]
[GROUP C]
[GROUP D]
Performs correction by the brightness sensor in multiple projectors in synchronization.
Up to four groups (A to D) can be set within the same subnet by using the network function.
Up to eight projectors can be registered and synchronized in one group.
11) Press
as
to select [CALIBRATION TIME].
12) Press the number (<0> - <9>) buttons on the remote control to enter the time.
f
The projector will go into the adjustment mode (the time is blinking).
f
Press
qw
to select “hour” or “minute”.
f
[CALIBRATION TIME] is set when the cursor is moved from [CALIBRATION TIME] using
as
.
f
Brightness and color are measured at the specified time. The dynamic contrast function does not operate
during measurement.
f
Use
as
to select [CALIBRATION TIME] (time is not flashing) and press the <DEFAULT> button if the time
is not to be specified.
13) Press
as
to select [CALIBRATION MESSAGE].
14) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[ON]
Displays message during calibration.
[OFF]
Does not display the message during calibration.
15) Press the <ENTER> button to proceed to the initial setting.
