Panasonic PT-RQ32KU, Operating Instructions Manual

Page: 172 / 285

Chapter 4 Settings — [PROJECTOR SETUP] menu
172 - ENGLISH
2) Press the <ENTER> button.
f
The [RS-232C] screen is displayed.
3) Press
as
to select [RESPONSE(ID ALL)].
4) Press
qw
to switch the item.
[ON] Returns the response when an ID is designated as ALL.
[OFF] Does not return the response when an ID is designated as ALL.
5) Press
as
to select [GROUP].
6) Press
qw
to switch the item.
[A] - [Z]
Controls multiple projectors simultaneously by sending the ID of RS-232C. You can set groups from
[A] to [Z]. The projector responds when the ID of RS-232C matches the setting.
7) Press
as
to select [RESPONSE(ID GROUP)].
8) Press
qw
to switch the item.
[ON] Returns the response when an ID is designated as GROUP.
[OFF] Does not return the response when an ID is designated as GROUP.
Note
f
When [INPUT SELECT] is set to [DIGITAL LINK], communication using that serial terminal is available only when the corresponding device
(such as the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G)) is connected to the <DIGITAL LINK/
LAN> terminal.
f
When transferring logos via the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G), setting for “NO
SIGNAL SLEEP” of the DIGITAL LINK output supported device should be set to “OFF” to avoid interruption of communication.
f
When [INPUT SELECT] is set to [DIGITAL LINK], communication speed for input is fixed to 9 600 bps and the parity is fixed to “NONE”.
[REMOTE2 MODE]
You can set the <REMOTE 2 IN> terminal.
1) Press
as
to select [REMOTE2 MODE].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[DEFAULT]
Uses pin assignment of the <REMOTE 2 IN> terminal in standard setting. (
x
page 249)
[USER] Changes the setting of the <REMOTE 2 IN> terminal.
f
When [USER] is selected, proceed to Step 3) .
3) Press the <ENTER> button.
4) Press
as
to select one from [PIN2] to [PIN8], and press
qw
to switch the setting.
[FUNCTION BUTTON]
Set the function of the <FUNCTION> button on the remote control.
1) Press
as
to select [FUNCTION BUTTON].
2) Press the <ENTER> button.
f
The [FUNCTION BUTTON] screen is displayed.
3) Press
as
to select a function.
[DISABLE] Disables the <FUNCTION> button.
[MULTI DISPLAY] Switches the [MULTI DISPLAY MODE] setting. (
x
page 179)
[SUB MEMORY] Displays the sub memory list. (
x
page 184)