Panasonic PT-RQ32KU, Operating Instructions Manual

Page: 249 / 285

Chapter 7 Appendix — Technical information
ENGLISH - 249
r
Lens control command
Command Sub command Details Remark
VXX LNSI2 Lens H shift
+00000 = Fine adjustment 1+, +00001 = Fine adjustment 1 - , +00100
= Fine adjustment 2+, +00101 = Fine adjustment 2 - , +00200 = Coarse
adj, +00201 = Coarse adjustment -
VXX LNSI3 Lens V shift
VXX LNSI4 Lens focus
VXX LNSI5 Lens zoom
<REMOTE 2 IN> terminal
It is possible to control the projector remotely (by external contact) from a control panel located away from the
projector where remote control signals cannot reach.
Use the <REMOTE 2 IN> terminal on the connecting terminals of the projector to connect to the control panel.
Remote control Contact control
Remote control/contact control
Standby Lit
Light source
SDI1 SDI3
SDI2 SDI4
DIGITAL LINK
Installation locations in meeting rooms, etc. Remote control board in another location
Pin assignments and signal names
D-Sub 9-pin
Outside view
Pin No. Signal name Open (H) Short (L)
(1) (5)
(6) (9)
(1) GND ― GND
(2)
POWER OFF ON
(3) SDI1 Other SDI1
(4) SDI2 Other SDI2
(5) SDI3 Other SDI3
(6) SDI4 Other SDI4
(7) DIGITAL LINK Other DIGITAL LINK
(8) SHUTTER OFF ON
(9) ENABLE / DISABLE
Controlled by remote
control
Controlled by external
contact
Attention
f
When controlling, make sure to short-circuit pins (1) and (9).
f
When pins (1) and (9) are short-circuited, the following buttons on the control panel and the remote control are disabled. Commands for
RS-232C and network functions corresponding to these functions are also disabled.
g
Power on <
b
> button, power standby <
v
> button, <SHUTTER> button
f
When pins (1) and (9) are short-circuited, and then any pins from (3) to (7) and the pin (1) are short-circuited, the following buttons on the
control panel and the remote control are disabled. Commands for RS-232C and network functions corresponding to these functions are also
disabled.
g
Power on <
b
> button, power standby <
v
> button, <DIGITAL LINK> button, <DVI-D> button, <HDMI> button, <SDI> button, <SDI 1/2>
button, <SDI 3/4> button, <SLOT 1> button, <SLOT 2> button, <INPUT MENU> button, <SHUTTER> button
Note
f
For pin (2) to pin (8) settings, you can make changes if you set [REMOTE2 MODE] to [USER]. (
x
page 172)