31
TV-SYSTEM
(for composite/S-video only)
AUTO1: Automatically selects the TV standard that
matches the input video signal, out of NTSC,
PAL, NTSC4.43, and SECAM.
AUTO2: Automatically selects the TV standard that
matches the input video signal, out of NTSC,
PAL-M, and PAL-N.
• Normally “AUTO1” or “AUTO2” should be chosen for
this option.
• If input video signal quality is poor, choose the TV
system that matches the input video signal.
Automatically selected by detecting the horizontal/vertical
scan frequencies and color sub-carrier listed in the table
below:
SIGNAL MODE
(for RGB/YP
B
P
R
/DVI signals only)
“SIGNAL MODE” displays the names of the signals
(resolution) presently applied to the RGB or YP
B
P
R
input ports. For details of signal names, see the table
on page 48.
If the user mode is registered, the following menu
will appear. You can choose either “AUTO” or a
registered user setting from “USER1” to “USER3” with
the
or
buttons.
If “AUTO” is chosen, a setting closest to the user
setting is automatically selected. (In the example
above, only “USER1” is registered for user address.)
W.BAL (White balance) R/G/B
(for RGB/DVI signals only)
White balance may be adjusted for each color to
correct reddish or bluish tones in white portions of
the picture:
button: Deepens the selected color.
button: Weakens the selected color.
Note
• Separate sets of adjustment parameters can
be saved for the RGB1, RGB2 and DVI inputs.
TV-SYSTEM
AUTO1
AUTO2
NTSC
NTSC4.43
PAL
PAL-M
PAL-N
SECAM
T a b l e
H . S c a n
F r e q u e n c y
( k H z )
V . S c a n
F r e q u e n c y
( H z )
C o l o r
S u b c a r r i e r
( M H z )
N T S C
N T S C 4 . 4 3
P A L
P A L - M
P A L - N
S E C A M
1 5 . 7 5
1 5 . 7 5
1 5 . 6 3
1 5 . 7 5
1 5 . 6 3
1 5 . 6 3
6 0 . 0 0
6 0 . 0 0
5 0 . 0 0
6 0 . 0 0
5 0 . 0 0
5 0 . 0 0
3 . 5 8
4 . 4 3
3 . 5 8
4 . 2 5 o r 4 . 4 1
STANDARD
Pressing the “ENTER” button resets all the
adjustment parameter values to the factory default
values, with a “STANDARD” indicator shown on the
upper right corner of the menu.
SIGNAL MODE
AUTO
USER1
Note
• If you choose a user address registered for a
signal that does not match the input signal, it is
regarded as no signal, and the projector will
display the specified background color.
