62
Using WebBrowser
(cont.)
This page indicates the projector status.
To access this page from other pages, click [Status] at the left of the window.
Monitor information window
The monitor information is refreshed at fixed intervals, but the current exact information can be checked by clicking [View]
ĺ
[Refresh].
Monitored information
On this window, click the [Status information] tab.
Network information
On this window, click the [Network status] tab.
If [SELF TEST Error(Detail)] appears on the monitored
information window, click it to view the error details.
If [FAILED] appears
Item
Description
MAIN CPU BUS
There is a problem with a microcontroller circuit. Contact your dealer.
FAN
There is a problem with the fan or fan drive circuit. Contact your dealer.
INPUT/OUTPUT AIR TEMP.
Excessive temperature by the air intake or around the lamp area.
The following may be causing the problem.
• The ambient temperature is too hot; the projector may be near a heater
• The exhaust vent is obstructed
LAMP REMAIN TIME
The lamp has been used for longer than its rated useful life, and it is time to replace it.
LAMP STATUS
The lamp could not be lit.
Allow the bulb of the light source to cool, and then turn on the projector.
ARF UNIT
ARF UNIT is not installed or remaining filter level is low.
See instruction manual of the projector for detail.
INPUT AIR TEMP.SENSOR
There is a problem with the air intake temperature sensor. Contact your dealer.
OUTPUT AIR TEMP.SENSOR
There is a problem with the exhaust temperature sensor. Contact your dealer.
BATTERY
The battery must be replaced. Contact your dealer.
