Setting
ENGLISH -
57
Settings
Lamp power
This function allows you to change brightness of the
screen.
Press ▲▼ to select [Lamp power] and
1 )
then press the <SELECT> button .
Press ▲▼ to select one among the
2 )
modes as below.
You can also press the <LAMP> button to
z
display [Lamp power].
Normal
Normal brightness.
Eco
Lower brightness reduces the
lamp power consumption and
extends the lamp life.
Remote control
This switching function prevents remote control
interference when operating several projectors or
video equipment at the same time.
Press ▲▼ to select [Remote control].
1 )
Press ► or the <SELECT> button.
2 )
Press ▲▼ to select one among the
3 )
two codes.
This projector provides 2 different remote
z
control codes: [Code 1] and [Code 2].
Note
When different codes are set on the projector and on the
z
remote control, any operation cannot be made. In that
case, switch the code on the remote control to fit the
code on the projector.
If the batteries are removed from the remote control for a
z
long period of time, the remote control code will be reset.
Security
This function allows you to use the Key lock and PIN
code lock function to set the security for the projector
operation.
Press ▲▼ to select [Security].
1 )
Press ► or the <SELECT> button to
2 )
access the submenu.
Key lock
J
This function locks the control panel and remote
control buttons to prevent operation by unauthorized
persons.
Press ▲▼ to select the desired items
1 )
as below.
Unlocked.
Lock the operation of the control
panel. To unlock, use the remote
control.
Lock the operation of the remote
control. To unlock, use the control
panel.
PIN code lock
J
This function prevents the projector from being
operated by unauthorized persons and provides the
following setting options for security.
Press ▲▼ to select the desired items
1 )
as below.
Off
Unlocked.
On 1
Enter the PIN code every time
turning on the projector.
On 2
Enter the PIN code to operate
the projector once the power cord
is disconnected; as long as the
AC power cord is connected, the
projector can be operated without
a PIN code.
Note
Whenever you change the PIN code lock setting or the
z
PIN code (the four-digit number), you are required to
enter the PIN code. The "1234" is set as the initial PIN
code at the factory.
