40 English
40
Setting
Continued
Pre-setting 2 (pairing)
Pair the transmitter to be used with one of the receivers for which “Pre-setting 1” has been
completed.
Standby screen after the completion of pre-setting
Group ID (Cast Group set as above) and “Mode: Multicast” are displayed at the bottom.
Since the Multi-screen mode is not supported, the operation guide display is changed.
Since the transmitter during Multicast is connected via external wireless LAN, the number of
connections is displayed here.
Note
•When the Multicast setting is changed, pairing of the transmitter is required again.
•Depending on the network connection status, delay or other problems may occur in Multicast video. If the delay
concerns you, try wired LAN connection between the receiver and the router.
•When [Wireless Display] is set to [On], the Multicast function cannot be used. Accordingly, [Multicast] cannot
be set to [On].
•When [Multicast] is set to [On], the following functions are not supported.
- Multi-screen mode
- Operation with HID devices
- Mirroring from the PressIT application for Android/iOS
- Downloading of the pairing file
•Please note that when communication between the router and the receiver is unavailable for a certain period
of time, [Multicast] is forcibly set to [Off].
When communication between the router and the receiver is unavailable, a message is displayed in the
center of the standby screen as shown below.
If communication between the router and the receiver cannot be resumed while the message is displayed,
[Multicast] is forcibly set to [Off], and the receiver restarts. (When communication can be resumed, the
Multicast setting can be maintained.)
●
Download Pairing File
Download the pairing file and save it on a USB flash drive.
After downloading is complete, perform step 5 and the subsequent steps in “Pairing by saving a file to the USB
memory” (page 21) to copy the pairing file to the transmitter.
The receiver and transmitter of the TY-WPS1/TY-WPS1W basic set are paired at the time of shipment. When the
transmitter is initialized or a new transmitter is additionally purchased, pairing with the receiver is required before
using.
