Fig. A
Fig.B
Video
Shield
Alarm In 1
Alarm In 2
Alarm Out
Alarm Out
Heater/Blower
Heater/Blower
Alarm In 3
Alarm In 4
Alarm In Common
Camera Power
Camera Power
A
B
C
D
E
F
G
H
R
J
K
L
M
N
P
U
T
S
Video
Shield
Heater/Blower
Heater/Blower
Camera Power
Camera Power
A
B
C
D
E
F
G
H
R
J
K
L
M
N
P
U
T
S
485
Fig. F (485 Control)
Fig. F (for fixed camera or coax control)
Video
Shield
Heater/Blower
Heater/Blower
Camera Power
Camera Power
A
B
C
D
E
F
G
H
R
J
K
L
M
N
P
U
T
S
Camera Ground
Fig. F (receiver preset)
Fig. C
7. Using the (4) 1/4 x 20 bolts and lock washers provided, secure
housing to the wall mount bracket.
8. Connect 18 pin external connector to the housing.
9. To gain access to the internal compartment of the housing
loosen (do not remove) (9) captive screws (
See fig. D
).
10.Attach unitized camera quick release bracket to housing
bracket (
Fig. E-1)
.
11.Install unitized camera. (Once installed it can be removed
without having to unscrew housing bracket.) (
Fig. E-2
)
12.Complete all wiring. (
Fig. E-3
)
13.Test function of all internal equipment before reattaching top.
Clean all interior surfaces of dome if necessary.
14.To reinstall top, carefully align notched area on the sides of the
housing top with shoulder bolts and wall mount bracket. Housing
top will drop in place if alignment is correct.
15.Secure all (9) of the captive screw fasteners. Fasteners need
only to be hand tighten. Do not over tighten.
16.Pressurize housing noting precautions mentioned above.
17.Attach wall mount cover to bracket.
Note:
The PPDW12 housing contains a strip of humidity sensitive
tape. Tape will appear blue under normal dry conditions and will
become pink if exposed to moisture or humidity.
Note:
The cap must be installed on the Schraeder valve (air input
valve) to ensure an airtight enclosure.
Fig. D
