46
UF-9000
JUN 2004
Ver. 2.0
DP-180/190
3.1.2.
Jam Error Codes (J Code)
Section
Jam Location
A
ADF
B
Paper Transport / Exit Area
C
Paper Entry Area
Jam Error Codes (J Codes) Table
Code
Contents
Section
J00
The Registration Sensor did not detect paper within a predetermined time after paper
started feeding. (Sheet Bypass)
C
J01
The Registration Sensor did not detect paper within a predetermined time after the
Paper Feed Roller started rotating. (1st Feeder Unit)
C
J02
The Registration Sensor does not detect paper within a predetermined time after the
Paper Feed Roller started rotating. (2nd Feeder Unit)
C
J43
The Exit Sensor does not detect paper within a predetermined time after the Fuser
Unit Paper Exit Sensor is activated.
B, C
J44
The Exit Sensor keeps detecting paper after a predetermined time.
B, C
J70
Read Point Sensor does not go ON within 10 seconds after the original starts feeding.
(Information Code 030 is printed on the Transaction Journal instead.)
A
J71
Original was longer than 78.7 in (2m).
(Information Code 031 or 032 is printed on the Transaction Journal instead.)
A
J79
The ADF Read Point Sensor keeps detecting paper in the ADF.
A
J80
The Automatic Duplex Unit (ADU) Entrance Sensor does not detect paper within a
predetermined time.
C
J82
The ADU Exit Sensor does not detect paper within a predetermined time after ADU
Middle Sensor is activated.
C
J83
The ADU Entrance Sensor keeps detecting paper after a predetermined time has
lapsed.
C
J90
The PRINT signal is not received within 1 minute after the FEED signal is received.
-
J91
The Paper Tray was pulled out when feeding a paper.
C
J92
The Front Cover was opened when feeding a paper.
C
J93
The paper remained in the ADF.
A
A
B
C
