22
For assistance, please call : 1-800-211-PANA(7262) or
send e -mail to : [email protected]
Camera Recording
Camera Recording
Remove the lens cap and clip it to the hand
strap.
1
Set POWER to CAMERA.
• The POWER Lamp lights red.
• Be sure POWER is fully turned to
CAMERA position.
2
With the Viewfinder Eye Cup up to
your eye, adjust the Vision
Adjustment Control to your eyesight.
(See page 9.)
3
Press REC/PAUSE to start recording.
• “REC” is displayed on the screen.
Press REC/PAUSE again to pause
recording.
• To reduce microphone wind noise,
set the WIND-CUT to ON. (See
WIND- CUT on page 15.)
EVF
To conserve power
After 5 minutes, the Record/Pause mode
will automatically change to Standby mode.
To resume recording, set POWER to OFF
and then ON again.
• When the Palmcorder is aimed at
excessively bright objects, or bright lights,
a vertical bar may appear in the picture.
This is a normal characteristic of the CCD
pick-up device. Try to avoid this whenever
possible.
WARNING:
• Do not leave the Palmcorder with the
EVF aimed directly at the sun as this
may cause damage to the internal parts
of the EVF.
• Do not lift, or carry, the Palmcorder by
the EVF or the LCD Monitor.
Simple Recording
Before you begin
• Connect the Palmcorder to a power
source. (See pages 11, 12.)
• Insert a cassette with record tab closed.
(See page 6.)
Zoom
You can gradually zoom in for close ups or zoom out for wide angle shots.
• The zooming speed ranges from a slow 22 seconds to a fast 2 seconds according
to the amount of pressure applied to the POWER ZOOM Switch.
Zoom slowly : by lightly pressing the “T” (Telephoto) or the “W” (Wide Angle) side of the
POWER ZOOM Switch.
Zoom quickly : by applying more pressure.
Note
REC/PAUSE mode
1
POWER
Switch
3
REC/PAUSE Button
Vision
Adjustment
Control
POWER ZOOM Switch
Clip here
POWER
Lamp
201_401.22-24.p65
01/01/18, 17:08
22
