Panasonic P7W, Service Manual, Page: 25 / 32

- 41 -
Service Manual
1080i Service mode (electronic controls, continued)
Note: Registers marked as FIXED are factory preset,
the default value must not be changed
Important note:
Write down the original values (“b” in the
adjustment mode details, figure 60) for each
address adjustment before modifying values.
Follow the procedure below to access the various
service adjustments. (Same procedures applies to
each section.)
a. Press
CH buttons on the remote control to select any of
the seven service sub adjustment addresses. (“a” in
figure 60)
b. Press
The buttons on the remote control to adjust the
level of the selected service adjustments.
MTS Adjustments Description Default Level New Level
MTSIN INPUT LEVEL N/A
SEPAL LOW LEVEL SEPARATION N/A
SEPAH HIGH LEVEL SEPARATION N/A
CLOCK Adjustments Description Default Level New Level
CLOCK CLOCK N/A
VIDEO Adjustments Description Default Level New Level
COLOR COLOR 1C
TINT TINT 80
BRIGHT SUB-BRIGHTNESS 02 00
CONT SUB-CONTRAST 89
B-Y_G MAGENTA TINT ADJ 40
R-Y_A YELLOW TINT ADJ 80
CUT R RED CUT-OFF 01 FB
CUT B BLUE CUT-OFF 01 EC
R DR RED DRIVE 57
B DR BLUE DRIVE 70
I ABL ABL 00
C_OFF COLOR ADJ. CUT-OFF 00
HDEF Adjustments Description Default Level New Level
H POS HORIZONTAL POSITIONING 00 C2
H WID HORIZONTAL WIDTH 2B
PCC PINCUSHION CORRECTION 0C
EWCOR CORNER CORRECTION 03
EWTRA TRAPEZOID 08
HCORR HORIZONTAL CORRECTION 0E