Panasonic P7W, Service Manual, Page: 21 / 32

- 37 -
Service Manual
480i Service mode (electronic controls, continued)
Note: Registers marked as FIXED are factory preset,
the default value must not be changed
Important note:
Write down the original values (“b” in the
adjustment mode details, figure 60) for each
address adjustment before modifying values.
Follow the procedure below to access the various
service adjustments. (Same procedures applies to
each section.)
a. Press
CH buttons on the remote control to select any of
the seven service sub adjustment addresses. (“a” in
figure 60)
b. Press
The buttons on the remote control to adjust the
level of the selected service adjustments.
MTS Adjustments Description Default Level New Level
MTSIN INPUT LEVEL 21
SEPAL LOW LEVEL SEPARATION 06
SEPAH HIGH LEVEL SEPARATION 1A
CLOCK Adjustments Description Default Level New Level
CLOCK CLOCK 128
VIDEO Adjustments Description Default Level New Level
COLOR COLOR 13
TINT TINT 80
BRIGHT SUB-BRIGHTNESS 01 DB
CONT SUB-CONTRAST 89
B-Y_G MAGENTA TINT ADJ 40
R-Y_A YELLOW TINT ADJ 80
CUT R RED CUT-OFF 01 FB
CUT B BLUE CUT-OFF 01 EC
R DR RED DRIVE 57
B DR BLUE DRIVE 70
I ABL ABL VARIABLE
C_OFF COLOR ADJ. CUT-OFF 00
HDEF Adjustments Description Default Level New Level
H POS HORIZONTAL POSITIONING 01 48
H WID HORIZONTAL WIDTH 1D
PCC PINCUSHION CORRECTION 20
EWCOR CORNER CORRECTION 03
EWTRA TRAPEZOID 08
HCORR HORIZONTAL CORRECTION 0D