– 75 –
Chapter 4 Adjustments and Settings for Recording — Viewfinder status display
[ ] flashing
The card is being recognized.
[ ]
No card inserted
[ ]
The card is write-protected.
[ ]
No remaining free space
[ ]
The card cannot be recognized.
[ ]
The P2 card is in an illegal format. (This can be corrected by formatting the card.)
36 Recording/playback operation status display
[REC]
Recording
[PAUSE]
Standing by for recording
[
&
]
Playback paused
[
w
]
Playback
[
)
][
%
]
Fast-forward/fast-forward playback (fast-reverse/fast-reverse playback)
[4X
)
][4X
%
]
4x search
[CLIP
&w
]
[CLIP
q&
]
Clip feed (clip return), cue up by individual clip units
[CLIP&T
&w
]
[CLIP&T
q&
]
Cue up by clip and text memo unit feed (return) (When the [SEEK SELECT] item on the menu [OTHER FUNCTIONS] screen is set
to [CLIP&T])
[START]
Displayed when recording of a new clip is started by one-clip recording.
[END]
Displayed when combining of clips has ended by one-clip recording.
In the display off status, only [REC], [START], and [END] are displayed at the top right. These are also displayed when pre-recording, loop recording,
interval recording, and one-shot recording are set.
r
Special recording status display
This is displayed when the [REC FUNCTION] item on the setting menu [RECORDING SETUP] screen is set to [INTERVAL], [ONE SHOT], and
[LOOP], or when pre-recording is set to [ON].
[L-]
[LOOP] (loop recording)
[I-]
[INTERVAL] (interval recording), [ONE SHOT] (one-shot recording)
[P-]
[PRE REC] (pre-recording)
37
System tally
Illuminated when the system tally is received, if using as the camera extension system in combination with the optional camera adaptor
(AG-CA300G) and base station (AG-BS300).
Information display in center
The following information is displayed (page 72).
P2 card recording/playback information display
[BOS]
Top of the stream. From here, playback in the reverse direction is not possible.
[CANNOT PLAY]
Displayed when playback is not possible.
[CARD ERR (1)], [CARD
ERR (2)], [CARD ERR (1/2)]
P2 card error in slot of indicated number
[UPDATING]
Card information is being read.
[CANNOT REC]
Displayed when recording cannot be started by pressing the <REC> button.
[EOS]
End of the stream. From here, playback in the forward direction is not possible.
[PRE REC ON], [PRE REC
OFF], [PRE REC INVALID]
Displayed when the <USER> buttons to which pre-recording is assigned are pressed.
[SHOT MARK ON], [SHOT
MARK OFF], [SHOT MARK
INVALID]
Displayed when the <USER> buttons to which the shot mark is assigned or the <RET> button on the lens are pressed.
[SLOT SEL], [SLOT SEL
INVALID]
Displayed when the <USER> buttons to which [SLOT SEL] is assigned are pressed.
[TEXT MEMO], [TEXT
MEMO INVALID]
Displayed when the <USER> buttons to which the text memo is assigned or the <RET> button on the lens are pressed.
Error and warning displays
These are displayed when an abnormality has occurred on the camera or the P2 card, etc. If the display is not corrected by turning the power off then
back on again, either follow the displayed instructions to replace the card, or contact the shop of purchase.
[CLIP DISCONTINUED]
Consistency with combined clips cannot be obtained by one-clip recording, and the clip cannot be combined at recording of the
next clip.
[DIR ENTRY NG CARD]
The P2 card directory is in an irregular layout. Operation is continued, however, data might not be recorded correctly.
Immediately back up the data on the card and use it after formatting it again.
[FORMAT ERR!]
The card does not conform to the P2 standard.
[INCOMPATIBLE CARD]
The card cannot be used since it conforms to a different standard.
