– 72 –
Chapter 4 Adjustments and Settings for Recording — Viewfinder status display
@
@
NOTE
t
[TC], [tc], and [UB] become white dropout display [ ]
→
[ ] when locked to TC IN input.
2
Warning information display
[ ]
Flashes when the P2 card is not inserted or recording is disabled.
[ FULL]
Flashes where there is no space remaining on the P2 card.
[ LACK]
Flashes when there is insufficient remaining space on the P2 card while loop recording is set.
[ ]
Illuminated when the built-in battery for the internal clock is flat.
For details, refer to “Charging the built-in battery” (page 156).
3
HD SDI REMOTE recording status and UPLINK device connection information
f
This indicates the recording start and stop control status for the external device connected by <SDI OUT/IN (OP)>.
f
This is displayed when the setting of the [HD SDI REMOTE] item on the setting menu [IN/OUT SEL] screen is [ON].
[SDI
n
]
Recording control instruction status for externally connected device
[SDI
&
]
Recording standby instruction status for externally connected device
f
For details on UPLINK device connection information, refer to the operating instructions of Upgrade Software Key AG-SFU603G (UPLINK device
control function (extra-cost option)).
4
Recording format and system mode display
System mode
f
1080i
f
1080 (1080-23.98PsF mode)
f
720P
f
480i
f
576i
Recording format
f
When the system mode is 1080i, 720P
- [AVC-I100]: AVC-Intra 100 format
- [AVC-I50]: AVC-Intra 50 format
- [DVCPROHD]: DVCPRO HD format
f
When the system mode is 480i (576i)
[DVCPRO50], [DVCPRO], [DV]
5 Information display
The following information is displayed according to the status:
f
Auto white balance and auto black balance operation status
f
Warning displays, error displays
f
Switch and button operation information
For details, refer to “Information display in center” (page 75).
6 System frequency display
Displays system frequency.
[60]
When the system frequency set by the [SYSTEM MODE] item on the setting menu [SYSTEM SETUP] screen is 59.94 Hz
[50]
When the system frequency set by the [SYSTEM MODE] item on the setting menu [SYSTEM SETUP] screen is 50 Hz
[24] (option)
When the system frequency set by the [SYSTEM MODE] item on the setting menu [SYSTEM SETUP] screen is 23.98 Hz
7
Proxy information display (option):
Displayed when the video encoder board (extra-cost option) is installed.
[
END]
Flashes white when there is less than one minute of recording space left. It is displayed during recording.
[
***min]
Displayed only during a mode check executed on the proxy SD memory card capacity.
[PROXY ERR]
Displayed when an error has occurred on the video encoder board or in proxy recording.
8 Letterbox recording display
Displayed when the recording format is 480i or 576i, and [LETTER BOX] is selected at the [ASPECT CONV] item on the setting menu [SYSTEM
SETUP] screen is selected and letterbox recording is being executed.
9 Y GET brightness display
In the Y GET mode, the image level in the frame displayed near the center of the screen is displayed as 0% to 109%.
10 Extender
Displays [EX] when the lens extender is used.
11 Recommended ND filter display
Displays the ND filter recommended for the current shooting conditions.
