Panasonic Over The Range Microwave Oven, Instalaltion Manual, Page: 4 / 8

Page 4
Fig. D-c-1
Fig. D-c-2
Knockouts Parts "A"
Back plate
Parts "A"
Fig. D-c-3
blower
unit
exhaust
parts
c. Rear Exhaust
Fig. D-c-4 Fig. D-c-5
exhaust
parts
back plate
blower unit
blower unit
mounting screws
blower plate
mounting screws
blower unit
mounting screws
blower unit
exhaust parts
blower plate
back plate
blower unit
1. Remove two blower cover plate mounting screws and two blower unit mounting screws, top and rear.
(Fig. D-b-1)
2. Remove the blower cover plate from the product. (Fig. D-b-2)
3. Carefully lift the blower unit and put it on top of product. (Fig. D-c-1)
4. Use side cutters or tin snips to cut and remove knockout parts "A" from back plate. Discard knockouts. File
the openings smooth to prevent injury caused by sharp edges. (Fig. D-c-2)
5. Turn blower unit right to left. Then rotate blower unit 90 degrees so the exhaust ports are facing toward the
rear of the product. (Fig. D-c-3)
6. Replace blower unit back into product. Be careful not to pinch the lead wires between blower unit and oven top.
Make sure the fan blades are visible through the exhaust openings on the back plate. (Fig. D-c-4)
7. Replace blower cover plate onto the product. Secure blower unit with two screws, one through blower plate the
other through oven back plate. Secure blower cover plate onto the product top with two screws. (Fig. D-c-5)
8. Slide two tabs of ventilation exhaust covers into two small square openings of blower cover plate so that two
large openings are covered. Secure each with one screw. (Fig. D-b-5)
Make sure two tabs are inserted into square holes and the screw heads are not protruding from blower cover
plate surface.
Two ventilation exhaust covers (Hardware item No. 7) and the screws (Hardware item No. 8) are shown on
page No.2
B
INSTALLATION HARDWARE, and can be found in your product package.
Note: Exhaust Adaptor must be secured onto bracket assembly before installing it on the wall.
See the instructions
F
PREPARATION OF TOP CABINET AND WALL for details.