Panasonic OCU-R200SF, Service Manual

Page: 12 / 52

General precautions
12
Water will released from the unit after rain or, in some cases,
after defrosting process. Do drainage work, if necessary.
In the cold weather regions, ensure that the unit is not exposed to snow
in winter, and that freezing and frost formation are minimized, for
example by covering the unit with a roof.
Ensure that discharge wind from condenser and noise from the
compressor would not annoy the neighborhood.
Unloading Transportation
In a place where is well drained
In a place where there is no influence of snow
In a place where the floor is robust and level
In a place where is heat-proof
Install the unit in a well-ventilated place where air
temperatures to condenser less than 43°C for better heat release.
Do not install the unit in a place where the unit would be
influenced by corrosive gas (salt water, toilets, incinerators,
wastewater treatment facilities, chemical plants, exhaust from
cars or heaters, etc.)
Delivery · Installation
Install the unit on the robust foundation so that noise would
not be amplified. Attention should be taken for the boundary
with neighbors and niose level regulation.
For the installation of the equipment, select a location where it is easy to do construction work and to perform daily operation and maintenance.
Page
Install the unit so that the unit would not be influenced by
sunlight reflection from the floor.
Selection of Installation Location
In a place where not disturb neighbors In a place where easy for maintenance
Measure Against Strong Wind
In a place where it is well-ventilated and where it is
environmentally safe
① ① As for distance between the equipment, select a place where the length of piping and wiring become as short as possible, and
where it is easy to do construction work.
② ②
Install the equipment in a place where it is easy to do daily inspection and maintenance work. (Daily inspection and
maintenance includes checks of operation pressure, the moisture indicator, the filter dryer, the magnetic contactor, etc. )
Set the air outlet side of unit is at right angle to wind flow
direction.
Be sure to prevent the vibration of unit(especially compressor)
during transportation. Unload the unit with care so that the unit is kept upright as much as possible.
Never allow the unit to lie on its side. When unloading the unit by forklift
truck, etc, place the unit on a pallet so that it can be kept upright.
Ensure that a space for maintenance and service work is
preserved.