Panasonic NV-HV61EE, Service Manual

Page: 144 / 159

39
7-2. MEMORY OF THE SELF-DIAGNOSIS HISTORY AND THE SUPPLEMENTARY DATA
This is effective only in Service Mode 3, 4, 5.
(1) Error Number and Supplementary Data
The Supplementary Data for each Error number are memorized.
Supplementary Data Memory No.
(Error No.) Reason
Data 1 Data 2
2*
(Refer to
Note:) An error while the PG Automatic
Adjustment VCR mode No Data
80 An exceptional ejection depends on a Error VCR mode Reason of Ejection
18 Detection of T-reel lock during the
constant tape running VCR mode Tape position
17 Detection of S-reel lock during the
constant tape running VCR mode Tape position
16 Detection of the Cylinder lock during the
constant rotation VCR mode Tape position
15 S-reel pulse cannot be detected when a
cassette tape is inserted.
(Error of the S-reel system or the Capstan
system.) VCR mode Counted value of S-reel pulse
14 An exceptional detection of the DOWN
position during the unloading. No Data No Data
08 The recording circuit is operated in except
for REC mode. VCR mode No Data
07 The recording circuit can not be operated in
REC mode. VCR mode No Data
06 Mechanism lock during the Cassette-up. VCR mode Stand-by position
05 S-reel pulse cannot be detected when a
cassette tape is inserted.
(Error of the S-reel system or the Capstan
system.) VCR mode Tape position
04 Mechanism lock during unloading VCR mode Stand-by position
03 Mechanism lock during without the
unloading and the cassette-up. VCR mode Stand-by position
02 The CAP FG could not be detected. VCR mode No Data
01 The cylinder could not be started.
(Error of the cylinder or the cylinder driver.) VCR mode No Data
11 Cylinder clogs during the PLAY mode. VCR mode No Data
10 Dew detection. VCR mode No Data
* Details of “VCR mode” of the Supplementary Data (These values are hexadecimal indication)
0: STOP, 1: EJECT, 2: REW, 3: FF, 4:REV, 5: CUE, 6: SLOW, 7: POWEROFF, 8: PLAY, 9: STIL,
A: REC, B: REC PAUSE, C: ADUB, D: ADUB PAUSE, E: INSERT, F: INSERT PAUSE
Note: 2* is as follows.
F20 NG1 in the PG Shifter Automatic Adjustment
(The cylinder rotation is unstable during the automatic adjustment.)
F21 NG2 in the PG Shifter Automatic Adjustment
(The vertical sync signal is lacked while over 5 seconds on the alignment tape.)
F22 NG3 in the PG Shifter Automatic Adjustment
(The installing position of Heads to the cylinder is our of specification.
F23 NG4 in the PG Shifter Automatic Adjustment
(The servo is not locked to the cylinder for more than 10 sec.)
(Sample)