Before using
13
LSQT1290
ª
To cancel Quick Start
1
Set [SETUP] >> [QUICK START] >> [OFF].
(
-16-
)
≥
The status indicator goes off and the power
turns off if the mode dial is set to OFF while the
unit is in quick start standby mode.
≥
If the standby continues for approx. 30 minutes,
then the status indicator will go off and the
camera will be completely turned off.
≥
In the following cases, quick start is cancelled
and the power turns off.
≥
When the Mode dial is moved.
≥
When the battery or AC adaptor is removed.
≥
When the tape is removed while using the
battery in Tape Recording Mode.
≥
When the movie camera is quick-started with
the white balance on automatic, it may take
some time until the white balance is adjusted if
the scene being recorded has a light source
different from the scene last recorded. (When
the colour night view function is used, however,
the white balance of the scene last recorded is
retained.)
≥
If the power is turned on in quick start standby
mode, the zoom magnification becomes 2
k
and
the picture size may differ from what it was
before quick start standby mode.
≥
If [POWER SAVE] (
-38-
) is set to [5 MINUTES]
and the unit automatically goes into quick start
standby mode, close the LCD monitor and
retract the viewfinder and then open the LCD
monitor or extend the viewfinder again.
Inserting/removing a cassette
1
Fit the AC adaptor or the battery and turn on
the power.
2
Slide the [OPEN/EJECT] lever and open the
cassette cover.
≥
When the cover is fully opened, the cassette
holder will come out.
3
After the cassette holder is opened, insert/
remove the cassette.
≥
When inserting a cassette, orient it as shown
in the figure, and then securely insert it as far
as it goes.
≥
When removing, pull it straight out.
4
Push the [PUSH] mark
1
in order to close
the cassette holder.
≥
The cassette holder is housed.
5
Only after the cassette holder is completely
housed, close the cassette cover tightly.
≥
When inserting a previously recorded cassette,
use the blank search function to find the position
where you want to continue recording. If you are
overwriting a previously recorded cassette, be
sure to find the position where you want to
continue recording.
≥
When closing the cassette cover, do not get
anything, such as a cable, caught in the cover.
Caution:
Take care not to trap your fingers under the
cassette holder when closing it.
OPEN/
EJECT
1
PUSH
LSQT1290_ENG.book 13 ページ ２００８年３月４日 火曜日 午後２時２０分
