Before Use
68
3
Insert the Battery Holder into the Remote
Controller.
≥
When the button-type battery is exhausted,
replace it with a new CR2025 battery. (A battery
is normally expected to last about 1 year.
However, it depends on operation frequency.)
≥
Make sure to match the poles correctly when
inserting the battery.
ª
Using the Remote Controller
1
Direct the Remote Controller at the Remote
Control Sensor
(36)
of the Movie Camera
and press an appropriate button.
≥
Distance from the Movie Camera: Within
approximately 5 metres
≥
Angle: Within approximately 10
o
in the
upward, and 15
o
in the downward and
horizontal directions from the central axis
≥
The above operating ranges are for indoor use.
Outdoors or under strong light, the Movie
Camera may not operate properly even within
the above ranges.
≥
Within a 1-metre range, you can also use the
Remote Controller on the LCD Monitor side of
the Movie Camera.
CAUTION
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or
equivalent type recommended by the
equipment manufacturer. Discard used
batteries according to manufacturer’s
instructions.
WARNING
Risk of fire, explosion and burns. Do not
recharge, disassemble, heat above 100
x
C or
incinerate. Keep the Button-Type battery out
of the reach of children. Never put
Button-Type battery in mouth. If swallowed
call your doctor.
10˚
15˚
15˚
15˚
(36)
Selecting Remote Controller Modes
When 2 Movie Cameras are used
simultaneously, they can be operated individually
by selecting different Remote Controller Modes.
≥
If the Remote Controller Mode of the Movie
Camera and that of the Remote Controller do
not match, [REMOTE] Indication is displayed.
Setup on the Movie Camera:
Set [REMOTE] on the [INITIAL] Sub-Menu to the
desired Remote Controller Mode. (
-76-
)
Setup on the Remote Controller:
[VCR1]: Press the [
D
] Button and [
∫
] Button
simultaneously.
1
[VCR2]: Press the [
E
] Button and [
∫
] Button
simultaneously.
2
≥
When the battery in the Remote Controller is
replaced, the mode is automatically reset to
[VCR1] Mode.
Power Supply
ª
Using the AC Adaptor
1
Connect the DC Input Lead to the Movie
Camera.
2
Connect the DC Input Lead to the AC
Adaptor.
3
Connect the AC Mains Lead to the AC
Adaptor and the AC mains socket.
≥
The AC Mains Lead’s outlet plug does not fit
entirely into the AC Adaptor socket. A gap will
remain as shown
1
.
≥
Before connecting or disconnecting the
power supply, set the [OFF/ON] Switch on
the Movie Camera to [OFF] and make sure
that Power Lamp is not lit.
INDEX
INDEX
SELECT
STOP
K
L
∫
STILL ADV
W
PAUSE STILL ADV
6
1
5
;
E
D
P.B. ZOOM
2
1
1
400GC.book 68 ページ ２００４年６月３日 木曜日 午後８時３３分
