Before using
64
LSQT0892
ª
Selecting the remote control mode
If 2 cameras are used simultaneously, set the
mode for one pair of movie camera and remote
control to [VCR1] and that of the other pair to
[VCR2]. This will prevent interference between
the 2 pairs. (The default setting is [VCR1]. When
the button-type battery is replaced, the setting will
revert to the default [VCR1].)
1
Setting on the camera:
Set [SETUP] >> [REMOTE] >> [VCR1] or
[VCR2].
2
Setting on the remote control:
[VCR1]:
Press [
D
] and [
∫
] simultaneously.
1
[VCR2]:
Press [
E
] and [
∫
] simultaneously.
2
ª
Concerning the button-type battery
≥
When the button-type battery runs down,
replace it with a new battery (part number:
CR2025). The battery is normally expected to
last about 1 year, but it depends on operation
frequency.
≥
Keep the button-type battery out of the reach of
children.
≥
If the remote control mode of the camera and
that of the remote control do not match with
each other, “REMOTE” will appear. When the
remote control is operated for the first time after
the camera is turned on, “CHECK REMOTE
MODE” (
-90-
) will appear and operation is
impossible. Set the same remote control mode.
≥
The remote control is intended for indoor
operation. Outdoors or under strong light, the
movie camera may not operate properly even
within the usable ranges.
Free style remote control
This controller can be used from different high
and low angles. It is also handy when a tripod is
used. When you do not use the controller, attach
the clip to the grip belt. Left-handed users can use
this camera more easily.
(1)
Recording start/stop button [REC]
(2)
Zoom lever [W/T]
(3)
Photoshot button [PHOTO SHOT]
ª
Connect the free style remote control
to the camera
1
Plug the free style remote control into the
[REMOTE] terminal as far as it goes.
ª
About the clip (on the backside)
When you move with the clip fitted to your pocket
or elsewhere, beware of knocking over the tripod
and causing the camera to fall off the table.
≥
If the pin plug of the control is not inserted
securely into the [REMOTE] terminal as far as it
will go, normal operation may not be ensured.
≥
Before using, make sure that the plug is
inserted securely into the terminal as far as it
will go.
STOP
STILL ADV
VOL
PAUSE STILL ADV
VAR
2
1
(1)
(2)
(3)
AV/
REMOTE
GS35_25GC.book 64 ページ ２００４年１２月２４日 金曜日 午後２時４７分
