Panasonic NN-SD65LS, Owner'S Manual

Page: 20 / 24

17
See below before calling for service, as most problems can easily be remedied by following these simple solutions:
The oven causes
TV interference.
Some radio and TV interference might occur when you cook with the
microwave oven. This interference is similar to the interference caused by
small appliances such as mixers, vacuums, blow dryers, etc. It does not
indicate a problem with your oven.
Steam accumulates
on oven door and
warm air comes
from the oven
vents. During cooking, steam and warm air are given off from the food. Most of the
steam and warm air are removed from the oven by the air which circulates
in the oven cavity. However, some steam will condense on cooler surfaces
such as the oven door. This is normal. After use, the oven should be wiped
dry (see page 16).
Oven will not turn
on.
The oven is not plugged in securely or needs to be reset; remove plug from
outlet, wait ten seconds and re-insert.
Main circuit breaker or main fuse is tripped; reset main circuit breaker or
replace main fuse.
There is a problem with the outlet; plug another appliance into the outlet to
check if it is working.
Oven will not start
cooking.
The door is not completely closed; close the oven door securely.
Dial was not pressed after programming; press Dial .
Another program is already entered into the oven; press Stop/Reset to
cancel the previous program and enter new program.
The program is not correct; program again according to the Operating
Instructions.
Stop/Reset has been pressed accidentally; program oven again.
The Glass Tray
wobbles.
The Glass Tray is not positioned properly on the Roller Ring or there is food
under the Roller Ring; take out Glass Tray and Roller Ring. Wipe with a
damp cloth and reset Roller Ring and Glass Tray properly.
When the oven is
operating, there is
noise coming from
the Glass Tray. The Roller Ring and oven bottom are dirty; clean these parts according to
Care and Cleaning of Your Microwave Oven (see page 16).
appears
in the display.
The CHILD SAFETY LOCK was activated by pressing Dial three times;
Deactivate CHILD SAFETY LOCK by pressing Stop/Reset three times.
Before Requesting Service