10.6. Turntable motor
1. Remove the motor cover by cutting at the locations
indicated by the arrows with a cutter.
NOTE:
After removing the motor cover, be sure that cut
portions are properly trimmed or bent to the inside
so that no sharp edges will be exposed to outside.
2. Disconnect 2 lead wires connected to the turntable motor.
3. Remove the turntable motor by removing screw.
NOTE:
After
replacing
the
new
turntable
motor
and
reconnecting the two lead wires, reinstall the motor
cover by rotating it 180°, tucking the tabs into the
base in the 2 provided slots, then screw the single
tab to the base using a 4mm X 6mm screw (not
provided).
10.7. Steam sensor
1. Disconnect connector CN2 from digital programmer circuit
board.
2. Disengage catch hooks on sensor cover c from orifice.
3. Remove steam sensor from orifice.
NOTE:
When installing the steam sensor, make sure that the
direction of steam sensor is as shown in figure.
18
NN-G463 / NN-S443 / NN-S423 / NN-S413 / NN-413
Summary of Contents for NN-K575MF
