Two screws to remove the turntable motor
9.8. Quartz Heater
1. Remove the sensor cable from the DPC connector CN7.
2. Remove the exhaust guide A by removing the two screws shown
in figure 10.
3. Disconnect the cables to the grill heater
4. Remove the grill cover by removing the 5 screws in figure 11
5. Remove the two screws holding the grill heater (Figure12).
6. Loosen the 2 screws holding the ceramic grill holders, turn the
holders to release the grill element.
7. Remove the heater bracket D by using a flat blade screw driver to
lever back the tabs.
8. The grill element can now be removed from inside the oven.
Figure 10
Removing the exhaust guide and grill cover
Figure 11
26
Summary of Contents for NN-A850CB
