Panasonic NN-A850CB, Service Manual

Page: 21 / 52

6. Carefully remove the inverter PCB and support base from the oven.
7. Remove the air guide E by un-clipping the catch hooks
8. Remove the four screws holding the PCB to the inverter support
base.
Caution when replacing the inverter power supply (U)
1. Make sure that grounding plate is in place
2. Securely tighten the grounding screw through the side of the
chassis (Base).
3. Securely connect the 3 lead wire connectors
4. Make sure that the heat sink has enough space (gap) from the
oven. Take care not to touch any lead wire to the aluminium heat
sink because it is hot.
Figure 3
Removal of the inverter PCB
Figure 4
Disconnecting the PCB lock connector
9.3. Digital Programmer Circuit (DPC) and membrane key board.
NOTE: Ground any static electric built up on your body before handling the DPC.
21