– 21 –
How to Operate
E. BEEP TONE
The loudness of beep tone and the length of beep tone at the end of heating cycle can be set.
There are four levels of the loudness.
There are two options of the length of beep tone at the end of heating cycle.
The loudest level and 3 beeps are preset at the factory.
X
To Select Loudness Level and Length
“
3 beeps
”
:
PAD
INSTRUCTION
DIGITAL DISPLAY WINDOW
1
PROG
Press Program Entry Switch.
“PROG” sign will start to blink in the display window. (The door may
be open or closed at this stage)
PROG
2
BUZZ
Press Buzzer Switch.
The tone will sound at its loudness level and the loudness level “3”
followed by the word “bEEP” will appear. “PROG” will start to blink
and 1st Stage Heating Indicator “1” (the length of beep tone
“3 beeps”) will be indicated.
Note:
Repeatedly pressing the Buzzer Switch will lower the loudness
level all the way to silent. (3bEEP — loudest, 2bEEP — middle,
1bEEP — quietest, and 0bEEP — silent)
1
PROG
3
PROG
Press Program Entry Switch again.
“PROG” will stop blinking. That means that you have completed
program.
Three seconds later, the display window will go blank when the
door is closed.
1
PROG
X
To Select Length of Tone
“
short beeps for 60 seconds
”
:
PAD
INSTRUCTION
DIGITAL DISPLAY WINDOW
4
Follow step 1-3 on page 21.
1
PROG
5
BUZZ
Within three seconds after pressing Program Entry Switch at
step 3, press Buzzer Switch.
“PROG” will start to blink and 2nd Stage Heating Indicator “2” (the
length of beep tone “short beeps for 60 seconds”) will be indicated.
PROG
2
6
PROG
Press Program Entry Switch again.
“PROG” will stop blinking. This means that you have completed
programming.
Three seconds later, the display window will go blank when the
door is closed.
PROG
2
