Panasonic NE-1878, Operating Instructions Manual

Page: 33 / 36

– 33 –
Self Diagnostics Failure Code Explanation
Installation Instructions for Stacking
This oven monitors its operation and displays a Failure Code in the Digital Display Window when a problem occurs.
CODE PROBLEM
rFL Splatter shield is removed. Place it back. The oven is inoperative without it.
U30 Memory cooking with double/triple quantity has exceeded the maximum cooking time.
Check and change the time. (See Step 3 “Note” on page 21.)
Press Stop/Reset Pad, and the code disappears.
U40 The temperature of electrical parts is too high. If the oven is operated without food, put the
food into the cavity and heat.
Press Stop/Reset Pad, and the code disappears.
F09 The oven is connected to 60 Hz. Connect to 50 Hz.
F code other
than F09
(F97, etc.) If the “F” code does not disappear even after pressing Stop/Reset Pad, pull out the plug
and then plug it in again after 5 seconds. The oven is faulty if the “F” code still appears.
Unplug the oven or shut off the power at the circuit breaker, and contact the dealer or a
service agent. (See page 10, MAINTENANCE OF YOUR OVEN.)


Joint Plate
Joint
Plate
Projection
Projection
Fig. 1 Fig. 2
Important
1. Disconnect the power cord from the wall socket
before attempting installation.
2. For stacking installation, you must use the
Panasonic Joint Plate A1134-3E11 (Available
via service route).
3. Combination of the unit for stacking is limited
within only the same models.
4. Do not stack more than one oven above bottom
oven.
Preparation
Be sure the oven cavity is empty.
Installation
1. Stack the units and remove five screws
a
as
shown in Fig. 1.
2. Loosen the screw
b
.
3. The projection on the Joint Plate must face
away from the oven. Place the Joint Plate on
the screw
b
.
4. Attach and tighten five screws
a
and the screw
b
. See Fig. 2.
5. Ensure the top oven is at a safe and workable
height.