Panasonic NCJD40C, Operating Instructions Manual

Page: 16 / 36

Keep Warm
60 85 98
Long Boil Cleaning
Dechlorination
h
Temp.
16
Water heating
When the water has been boiled, this will be announced
by a buzzer and will be shown on the display.
¥ Time until boiling
About 31 minutes
(Up to the top level mark with a room temperature of 20¡C.)
After a little while, the temperature will be maintained at .
3. The temperature will be maintained automatically.
Press during heating to display .
The boiling time is extended by about 3 minutes
and the purification effect is increased.
¥ Press
again to return to normal boiling.
Reboil
Reboil
Reboil
Buzzer sound
If an empty container is heated, the overheat safety
function (which prevents an empty container from
being heated) will be activated. The power will be
shut off automatically to prevent the problems that
can occur due to overheating. This will be shown on
the display.
When the container is heated with no water in it or with the
water level below the low water level line, a bad smell may
be caused or the fluororesin coating may become discolored.
Please observe the following.
¥
Do not connect the power without pouring water into the
container.
¥
Do not boil water when the level is too low.
¥
After water is added, do not leave the lid open.
Flashing alternately
Reboil
¥ How to cancel the display Pour water into the container,
and press the key.
Use long boiling to increase the
purification effect.
To Prevent an Empty Container from
Being Heated
60 85 98
Long Boil Cleaning
Dechlorination
h
Temp.
60 85 98
Long Boil Cleaning
Dechlorination
h
Temp.
Long Boil Cleaning
Dechlorination
h
Temp.
Long Boil
Lit
Lit
Goes out.
Buzzer sound