15
1
Make sure that the mesh
fi
lter is attached to the inner container.
2
Put citric acid in the inner container.
●
Amount of citric acid to be used at one time:
80 g (two packages) or seven level tablespoons
* In case that our citric acid is not available, place 1-2 sliced
lemons wrapped with a thin cloth into the inner container
instead.
(The detergency of lemon is less effective than using the citric
acid.)
The citric acid is available from an authorized dealer. (Model No: SAN-80N)
* Follow the directions for cleaning printed on the citric acid package.
* Since the citric acid used for cleaning is a food additive, it is harmless to humans.
3
Add water to the maximum water level mark,
and mix the citric acid and water well. Close
the lid.
4
Connect the plug immediately after stirring and press
key
more than 3 seconds.
Indications would
notice cleaning start.
Indications would
notice cleaning end.
Cleaning start
End of cleaning
Light on
Flashing
Cleaning time (approx.)
NC-EG4000: 50 min.
NC-EG3000: 42 min.
NC-EG2200: 35 min.
5
Dispense some water, then unplug, remove the lid and drain away the
hot water via the ‘DRAIN’ mark.
6
Re
fi
ll with water and boil it to remove the smell of the citric acid or
lemons. Then throw the hot water away as same as step
5
.
How to clean the inner container using citric acid.
Once every two or three
months to clear scale.
(
)
●
To remove any discoloration from the area above the maximum water level, rub the inside lightly with a wet
soft sponge.
●
If the discoloration cannot be removed by rubbing, clean the inner container several times using citric acid
or lemons.
Cautions
●
Please use citric acid to clean the inner container of this unit.
●
Do not
fi
ll with water above maximum water level.
●
Fill the inner container only with tap water (do not
fi
ll with hot water). Hot water may spout out causing
burns.
citric acid
Daily Maintenance
01_HK_OM_NC-EG2200_3000_4000_EN.indd 15
01_HK_OM_NC-EG2200_3000_4000_EN.indd 15
7/16/2558 BE 14:12
7/16/2558 BE 14:12
