Panasonic nanoe EH-NA9K, Operating Instructions Manual

Page: 11 / 32

11 11
3 Direct warm air throughout your
hair
Points
Your hair will dry quickly if you
direct the warm air towards the
roots.
4 After blowing your hair dry by
about 90 %, switch to hot /cold
alternating mode to leave your
hair shiny and pendent
Select with the mode switching
button
Points
In order to thoroughly apply hot
and cold air, part your hair to the
left and right to dry it.
1
Run your hand through your hair
from the inside while blowing it
in hot/cold alternating mode.
(One side)
2
Run your hand through your hair
from the top while blowing it in
hot/cold alternating mode.
(One side)
3
Repeat steps
1
and
2
on the
other side.
5 Set the power switch to [ O ]
6 Remove the plug from the household outlet
After drying, tidy your hair with a comb or your fingers.
Keep the unit at a dry place after it has completely
cooled down.
Caution
Keep a distance of over 3 cm between
the air outlet and your hair.
Keep a distance of over 10 cm between
the air inlet and your hair.
Be careful not to hit the air inlet on the
corner of a desk.
Note
Styling and treatment appliances can be used
However, if you use sticky substances such as oil, gel
or wax, the intended effect of nanoe™ and mineral ions
may become difficult to achieve.
When nanoe™ ions are generated, the following cases
may occur:
Water droplets may be blown out of the nanoe™ outlet
during use.
You may hear a noise from the nanoe™ outlet.
You may notice a characteristic smell during use.
EH-NA9K 香港向1222.indb 11 2023/1/3 16:34:06