Panasonic NA-FS95G3, Service Manual

Page: 10 / 31

‐ 9 ‐
5. Test Mode
Check H Check G Check M Check E
Check A Check B Check C
(2) (1)
1. Set the power switch to "off".
2. Press and hold both the "Water lever" and "Wash" buttons with one hand.
3. Press the power switch to "on".
4. Release your fingers from the buttons and power switch which you pressed in steps (2) and (3) .
(Check A can be carried out in this state with your fingers released)
5. Within three seconds press the "Water lever " button to set the desirer check procedure.
(Carry out checks B, C, E, M, G and H)
Number of times
the "Water level"
button is pressed
Check
Procedure
Check Contents
Lamp Illumination
Condition
Operation Condition
0 A
•
Cycle end buzzer
•
Timer indicator
•
Auto power off
•
When the end buzzer sounds three times, the
lamps will simultaneously flash on and off in
the remaining time display, and the power will
automatically be switched off immediately
after operation is finished.
1 B
•
Washing
operation
•
Even if there is no water in the tub, the
washing operation will continue for 10
minutes.
•
Press the "Rinse" button once FV ‐ 1 operates,
and press twice to operate FV ‐ 2, press 3 time
hot water valve (FV ‐ 3) operates.
•
If the PCB fault occurred, an error indication
"H05" will display.
2 C
•
Spin operation
•
Lid/SF switch
•
The spinning operation will continue for 6
minutes.
•
Check the lid & SF switch operation, while
opening lid
1) "74L" lights up … Lid switch working
2) "86L" lights up … SF switch working