18
Drain Hose Installation Instruction
(The drain hose is installed inside the bottom of the base.)
1. Lay down the washing machine with the back
body facing to the upside.
Drain Hose
Rear
Tape
7
To change the drain hose to opposite.
(Ex. Changing hose position from right to left.)
1. Lay down the washing machine with the back
body facing to the upside.
2. Remove the screw
fi
xing the hose holder.
3. Remove the hose holder from the base.
Screw
Hose Holder
Bottom Cover Installation Instruction
A. Purpose
For safety precaution.
B. How to install Bottom Cover to the Base
4. Move the hose holder to opposite side. Then
insert the hose holder to left hose outlet position
of the base.
5. Fix the hose holder with screw properly.
For NA-F62B1
For NA-F70B1
Front
Caution
Make sure the hose holder is
fi
xed on the base properly
to avoid water leaking caused of the hose damaged.
Note
Make sure to remount the bottom cover after pulling out
the drain hose or changing its position.
Note
Do not remove the hose
holder from the drain hose.
Note
Make sure the drain hose
is not twisted.
3. Fix Bottom Cover (accessory) where surface
with UP indication is facing to the washing
machine. Then securely fasten the 9 screws of
the Bottom Cover to the Base.
Bottom Cover
Spread a mat such as cardboard under the body to avoid scratches.
Base
Drain Hose
Pull out.
Hose Hole Cover A
1. Lay down the washing machine with the back
body facing to the upside.
2. Adjust the Hose Hole Cover A (accessory) to the
slot at the base.
2. Peel off the tape and pull out the drain hose
from the base.
NA-F62-70B1-ENABPS.indd 18
NA-F62-70B1-ENABPS.indd 18
5/8/08 9:16:47 AM
5/8/08 9:16:47 AM
