Panasonic NA-127VB6WAE, Service Manual

Page: 12 / 50

12
7. Service Mode
7.1. Service Autotest
1. Set PR to program 3 (Colours) and press SW2 (
T°C)
1. 2. While pressing the SW2, change PR position from third to
second, and release the SW2 button.
2.
3. Bring PR to desired test step (1
st
2
nd
or 3
rd
program position) as soon as “SAU” is displayed on LCD.
LCD Display status:
I2 Door Lock Symbol -> Fixed on
SS3 -> SAU
11.
Step1 Step 2 Step 3
PR Position:
Program 1
(Cotton)
PR Position:
Program 2
(Cotton Prewash)
PR Position:
Program 3
(Colours)
Result Result Result
HEATER ON PUMP ON
TEST PROGRAM
ON
(Rapid 12’)
Comments :
When entering in
service test, door
will be locked.
Test is over
Door will be
unlocked, machine
will go to END state.
The test steps are as below ;
Step 1:
Selector Program 1 (Cotton)
will be “HEATER ON”
Before heating it should take water till first level frequency then
start heating.
Heater will be on max. 8 minutes after this 8 minutes if the temp.
doesn’t change more than 2°C then it will give NTC failure.
(E05).
Or if the NTC connection is broken then it should give again E05
NTC failure.
At the end of he
ating, “SAU” visualization should make slow
blink to indicate that the step is over.
Note: If user changes the selector position, machine will do what
is defined for the new selected position.
Step 3:
Selector position 3 (Colours) will be a 12 mins test program where all
functions of the appliance will be checked.
Machine will make exactly the same algorithm of Super Rapid 12'.
So, time for selector position 3 is 12 minutes.
At the end of test program “End” is visualized on LCD and door is
unlocked.
Step 2:
Selector Program 2 (Cotton Prewash)
will be “PUMP ON”
Temperature will be measured, if it is higher than 50 °C, it should
take 60 sec. cooling water, and then make “Drain + 5 sec.”
At the end of pump activation, “SAU” visualization should make
slow blink to indicate that the step is over.