Maintenance - 29
Maintenance
Replace the softener cover.
5.
Reinsert the detergent drawer while
6.
pressing down on the middle of the
softener cover.
Cleaning the water supply
filter
Clean the filter if water is not supplied
properly.
Turn the tap off.
1.
Switch on the appliance.
2.
Select the Cotton programme, and
3.
then press the Start button. Drainage
begins when the appliance is started.
After 2 minutes, switch off the
4.
appliance. Water has drained out of
the water supply hose
.
Disconnect the water supply hose
5.
from the appliance.
Clean the filter, which is on the rear
6.
of the appliance.
Use a small brush, for example,
a toothbrush.
Disconnect the hose from the tap and
7.
then clean the filter on hose in the
same way.
Reconnect the water supply hose.
8.
Tighten the plastic joint firmly.
Turn on the tap and then check for
9.
leaks.
Preventing a frozen water
supply hose
If the appliance is delivered in freezing
weather conditions, after setting up, leave
it at room temperature for 24 hours before
using. This will ensure that the water
supply hose does not become clogged up
with ice.
If your water supply hose freezes, perform
the following procedures:
Wrap warm towels around the joints
1.
of the water supply hose.
Add 2 to 3 litres of warm water to the
2.
drum.
Run the Drain programme. (P.18.)
3.
Joints Tap
approximately
50 °C
Water supply hose
Softener cover
2018-8-1 14:07:47
Summary of Contents for NA-106VC
Page 42: ...2018 8 1 14 07 52 ...
Page 43: ...2018 8 1 14 07 52 ...
