How to Use
To Grind Meat
Unplug when assembling the unit. Before plugging in, ensure the switch is off.
(Attaching)
1
Place the head onto the opening of the motor housing.
Holding the head with one hand and tighten the locking knob clockwise.
Place the feed screw into the head, long end first, by turning the feed
screw slightly until it is set into the slot of the head,
о If the feed screw is set properly, it does not turn.
Place the cutting blade onto the feed screw shaft with the blade facing
the front as illustrated.
о
Cutting surface should be faced to the cutting plate when being set,
otherwise meat will not be ground.
4
Place the desired cutting plate over the cutting blade, fitting protrusion
in the slots.
• If the cutting plate is not set properly, meat may leak out around
protrusion of motor housing. When meat leak out, clean around the
protrusion of motor housing.
W ipe with a well-wrung cloth.
Protrusion
Screw the cap into the head firmly.
Place the hopper plate on the head and fix it into position.
Set the unit on a firm surface.
•T h e air vents at the bottom and the side of the motor housing
should be kept free and not blocked.
6
Summary of Contents for MK-ZG1500
Page 12: ......
