13
REPLACEMENT OF MAIN PARTS
8. Remove from the motor rear /front motor supports and
noise suppressor. (Fig. 7)
Fig. 7
9. Replace the motor with a new one and connect yellow and
black lead wires to the carbon brush holder tabs.
NOTE: Yellow lead wire should be connected to carbon
brush holder tab marked with letter “P”.
10. Reassemble front / rear motor supports and noise
suppressor.
NOTE: Make sure the lead wires are correctly positioned to
avoid be pinched between parts and adjust the position of
the rear motor support to the proper motor cover position.
(Fig. 8)
11. Reassemble motor cover A and B and refasten the screws.
NOTE: Before reassemble motor cover A, check the
thermal cut-out is correctly placed in its holding. (Fig. 9)
12. Place the motor unit and cord reel ass’y into the lower body.
13. Connect the lead wires according to the schematic diagram
and reassemble the remaining parts in the reverse order.
Fig. 9
Fig. 8
Front motor
support
Rear motor
support
Motor
Noise
suppressor
Motor cover B
Thermal cut-out
Carbon brush
holder “P” marked
