Fig. 6
Upper body
cover
Screws
Fig. 7
Lead wire
connector
Power
board
Upper body
cover
Power
control
Fig. 8
Upper body
cover
Packing
Nut
Washer
Power
control
Fig. 9
Groove
Upper body
cover
Power
control
Fig. 10
Power
control
shaft
Knob
Mark
Power control
Knob
5.3. Removing upper body cover
1. Remove the mounting screws (4 pieces), and remove the
upper body cover. (Fig. 6)
2. Disconnect the lead wire connector of the power control
from the power board and remove upper body cover.
(Fig.
7)
5.4. Removing power control
1. Pull off the power control knob.
2. Remove the fastening nuts with hex. socket wrench and
remove the power control from upper body cover. (Fig. 8)
3. < Attaching power control >
Engage the stopper of the power control into the
groove on the rear side of the upper body cover, and
fasten the power control with the fastening nuts. (Fig. 9)
4. < Attaching knob >
As shown in the figure, position the cut surface of the
power control shaft and push in the knob aligning with the
mark of the upper body cover. (Fig. 10)
9
MC-E7305 / MC-E7305K / MC-E7303 / MC-E7303K / MC-E7302 / MC-E7301 / MC-E7301K
