Panasonic MC-CG677-SA76, Service Manual

Page: 8 / 20

8
4. Remove the P.C.B. Ass'y from the P.C.B. holder.
* When removing the P.C.B Ass’y, widen the frame of
the P.C.B holder, and then remove the P.C.B from the
hook of the P.C.B holder.
Note: When removing the P.C.B. assy, do not bend it
to prevent damage and the wires from breaking.
5. Remove the fastening terminal of the lead wire from cord
reel partition U connected to the printed circuit board and
that of the lead wire from the motor.
* Note: When removing the fastening terminal of the
lead wire, please hold the terminal fixed to the printed
circuit board to prevent an excessive load from being
applied to it.
6. Remove the Control and Lead wiire BU.
7. Remove the two screws fixing the P.C.B. holder and pull it
out from the lower body U.