VQT2S74
58
Advanced (Recording pictures)
∫
Set the position of the histogram
•
Set the [HISTOGRAM] in the [CUSTOM] menu to [ON]. (P125)
1
Press [Q.MENU] to display the Quick Menu. (P31)
2
Press
2
/
1
to select histogram, and then press [MENU/SET].
•
You can also use the rear dial to set.
3
Press
3
/
4
/
2
/
1
to set the position.
4
Press [MENU/SET] to finish the setting.
5
Press [Q.MENU] to close the Quick Menu.
•
You can also press the shutter button halfway to close the Quick
Menu.
•
Position of the histogram can be set from the [CUSTOM] menu too.
Note
•
When the recorded picture and the histogram do not match each other under the
following conditions, the histogram is displayed in orange.
–
When the manual exposure assistance is other than [
n
0EV] during Exposure Compensation
or in the manual exposure mode
–
When the flash is activated
–
When the flash is closed
•
When the brightness of the screen is not correctly displayed in dark places
•
When the exposure is not adequately adjusted
•
The histogram is an approximation in recording mode.
•
The histogram displayed in this camera does not match histograms displayed by picture editing
software used in PCs etc.
•
Histogram is displayed in R (red), G (green), B (blue), and Y (luminance) during the playback.
[REC] mode:
Taking Pictures using the Built-in Flash
A
To open the flash
Slide the flash open lever.
B
To close the flash
Press the flash until it clicks.
•
Be sure to close the flash when not in use.
•
The flash setting is fixed to [
Œ
] while the flash is
closed.
Note
•
Be careful not to catch a finger when closing a flash bulb.
Applicable modes:
Set the built-in flash to match the recording.
•
Open the flash.
Select [FLASH] in the [REC] mode menu. (P29)
Switching to the appropriate flash setting
DMC-G10KEB-VQT2S74_eng.book 58 ページ ２０１０年４月２３日 金曜日 午後８時３４分