Panasonic Lumix DMC-FX80PU, Service Manual

Page: 29 / 81

29
9 Measurements and Adjustments
9.1. Introduction
When servicing this unit, make sure to perform the adjustments necessary based on the part(s) replaced.
Before disassembling the unit, it is recommended to back up the camera data stored in flash-rom as a data file.
IMPORTANT NOTICE (After replacing the MAIN P.C.B.)
After replacing the MAIN P.C.B., it is necessary to use the “DIAS” software to allow the release of adjustment flag(s).
The Adjustment software “DIAS” is available at “TSN Website”. To download, click on “Support Information from NWBG/VDBG-
AVC”.
*DIAS (DSC Integrated Assist Software)
NOTE: (When replacing the Lens unit and CCD unit)
• When the CCD unit is unavoidably removed for Lens unit and CCD unit replaced, an optical tilt adjustment is necessary after
parts are exchanged.
• The adjustment software (DSC_Tilt) is necessary to execute an optical tilt adjustment.
• The adjustment software “DSC_Tilt” is available at “TSN Website”, therefore, access to “TSN Website” at “Support Information
from NWBG/VDBG-AVC”.
9.2. Before Disassembling the unit
9.2.1. Initial Setting Release
The cameras specification are initially set in accordance with model suffix (such as EB, EG, GK, GC, and so on.).
Unless the initial setting is not released, an automatic alignment software in the camera is not able to be executed when the align-
ment is carried out.
Note:
The initial setting should be again done after completing the alignment. Otherwise, the camera may not work properly.
Therefore as a warning, the camera display a warning symbol “ ! ” on the LCD monitor every time the camera is turned off.
Refer to the procedure described in “3.4.2 INITIAL SETTINGS” for details.
[ How to Release the camera initial setting ]
Preparation:
1. Attach the Battery or AC Adaptor with a DC coupler to the unit.
2. Turn the Power on.
3. Select with the touch panel in order to [ Recording Mode icon ] and [ NORMAL PICTURE ] mode.
4. Turn the Power off.
(If the unit is other than [ NORMAL PICTURE ] mode, it does not display the initial setting menu.)
Step 1. Temporary cancellation of “INITIAL SETTINGS”:
While pressing "W side of [ ZOOM LEVER ]", [ SHUTTER BUTTON ] and touch the screen (Any position of the screen is accept-
able) simultaneously, turn the Power on.
Step 2. Cancellation of “INITIAL SETTINGS”:
1. Select with the touch panel to [ PLAYBACK ] mode.
2. Touch Setup after touching MENU. Then, find and select [ Version Disp. ].
3. Touch near the center of [ Version Disp. ] screen, while [ SHUTTER BUTTON ] is pressed halfway.
4. Turn the Power off.
The LCD displays the “ ! ” mark before the unit powers down.