Panasonic LP-RH Series, Setup And Maintenance Manual

Page: 47 / 240

47
2-3-2 Installation method
• Install the head on a plate with a thickness of 10 mm to 15 mm which is made of aluminum or other material with
radiation performance equivalent to that of aluminum.
• For details of installation, refer to “1-4-1 Head” (P.29).
• Fix the head in the following conditions.
Head type Fixing surface Fixing screw Screw insert length Tightening torque
Standard head Bottom M6 screws at 6
positions
7 mm to 10 mm 3.0N
・
m
Tower head Rear 7 mm to 10 mm
Bottom
(laser emission port side)
5 mm to 7 mm
A
B
M6 screw
Laser marker head
A : Inserting length of the screw (See above table for the length.)
B : Washer thi stand thick
When installing the head, refer to the above table and fix the six M6 screw holes.
M6 screw
M6 screw
M6 screw
Tower head model Standard head model
ワㄐㄕㄊ㄄ㄆ
• Do not insert any screw of length exceeding the specification. Otherwise, the failure of the product may be caused.
ME-LPRH-SM-3