Panasonic LP-RH Series, Setup And Maintenance Manual

Page: 112 / 240

112
4-5 Connecting I/O Terminal Block
WARNING
• Make sure that the power is turned OFF at wiring.
4-5-1 Factory default wiring
The following terminals are connected by jumper wires at the factory default. Remove these jumper wires when you
connect them to an external device.
INTERLOCK 2(-)
INTERLOCK 2(+)
LASER STOP IN
LASER STOP IN
24V OUT 0V OUT
OUT COM. 1 IN COM. 1
OUT COM. 1
INTERLOCK 1(-)
INTERLOCK 1(+)
X1
X2
X3
X4
X5
X6
X7
X8
X9
X10
X11
X12
X13
X14
X15
X16
X17
X18
X19
X20
Y1
Y2
Y3
Y4
Y5
Y6
Y7
Y8
Y9
Y10
Y11
Y12
Y13
Y14
Y15
Y16
Y17
Y18
Y19
Y20
I/O terminal block
REMOTE INTERLOCK IN
Short-circuited
Short-circuited
Short-circuited
Short-circuited
Short-circuited
ワㄐㄕㄊ㄄ㄆ
• Do not short-circuit 24V OUT (X1, Y3) and 0V OUT (X3, Y1). Also, do not short-circuit IN COM. 1 (X2) and OUT COM.1
(Y2, X12). Starting the laser marker with these terminals short-circuited will cause the laser marker to malfunction.
ンㄆㄇㄆㄓㄆㄏ㄄ㄆ
• To enable the laser radiation, connect IN COM. 1 (X2) and OUT COM. 1 (Y2) respectively to the internal of external
power supply. Refer to “4-5-2 Connecting common terminals” (P.113).
• The following terminals of the I/O terminal block are the common terminals connected internally.
• X1 and Y3: 24V OUT
• X3 and Y1: 0V OUT
• Y2 and X12: OUT COM. 1
ME-LPRH-SM-3