Panasonic LP-GS Series, Setup & Maintenance Manual

Page: 95 / 190

95
4-6-3 Marking trigger input: Single trigger
When the trigger mode is set to “single trigger” in the file settings, one lasing operation is executed by the edge of turning
on of TRIGGER IN (X5).
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON (Normal)
OFF (Error)
ON (Normal)
OFF (Error)
T1
T5
T4
T2
T1
T4
T6
T2
T1
T3 T3 T3
READY OUT (Y5)
TRIGGER IN (X5)
PROCESSING FAIL
OUT (Y12)
WARNING OUT (Y14)
ALARM OUT (Y15)
PROCESSING OUT
(Y10)
PROCESSING END
OUT (Y11)
Marking
interruption
Marking
interruption
LASING OUT (Y20)
Item Time Remarks
T1 2ms or more Keep the ON status for 2ms or more.
T2 ― When TRIGGER IN (X5) is accepted, PROCESSING OUT (Y10) turns ON. The output time
of PROCESSING OUT (Y10) includes the trigger delay time, marking preparation time,
laser radiation time, and processing time after marking has completed.
If you are not using the link function with external devices, output time of PROCESSING
OUT (Y10) is almost the same as the total duration of the trigger delay time and LASING
OUT (Y20).
T3 0 to 9999ms When the trigger delay time is set in the selected file, trigger processing (lasing) operation
starts after the delay time.
T4 2 to 510ms This is the output to notify that the marking trigger processing completed normally. This
is One-shot output. Set the output time on the system settings screen. There is a small
margin of error for the setting value.
T5 Approx. 3 sec. It outputs a warning to notify that an invalid trigger was input when TRIGGER IN (X5) was
input during trigger processing. This is One-shot output. You can turn this warning off by
the settings.
T6 2 to 510ms If the trigger processing was stopped by an alarm or a warning, PROCESSING FAIL OUT
(Y12) turns on during the one-shot output period. PROCESSING END OUT (Y11) will not
be output at this time.
ME-LPGS-SM-8