5.1.2 Using the automatic document feeder
(KX-MB2010/KX-MB2025/KX-MB2030 only)
M
Copy
N
M
Stop
N
M
Start
N
1
If the
M
Copy
N
light is OFF, turn it ON by pressing
M
Copy
N
.
2
3
If necessary, change the copy size (original
document size and recording paper size), resolution
and contrast according to the type of document.
R
To select the copy size, see page 34.
R
To select the resolution, see page 34.
R
To select the contrast, see page 34.
4
If necessary, enter the number of copies (up to 99).
5
M
Start
N
R
The unit will start copying.
6
After you finish copying, press
M
Stop
N
to reset the
settings you set in step 3 and 4.
Note:
R
5.2 More copying features
R
Make sure that the
M
Copy
N
light is ON.
5.2.1 Zoom copy (enlargement / reduction)
1
2
Press
M
Zoom
N
repeatedly to select the zoom rate that
fits the size of your document and recording paper.
–
“
ZOOM =100%
”
–
“
50%
”
–
“
200%
”
*1 Press
MCN
or
MDN
repeatedly to change the zoom
rate by 1 % at a time from
“
25%
”
to
“
400%
”
.
You can also enter the desired percentage
specifically by using the dial keys.
3
M
Set
N
4
If necessary, enter the number of copies (up to 99).
A
M
Start
N
5
After you finish copying, press
M
Stop
N
to reset this
feature.
Note:
R
Zoom copy is not available for the following features:
– Quick ID copy feature (page 36)
– Image repeat feature (page 36)
– Poster feature (page 38)
– N in 1 feature (page 38)
– Separate N in 1 feature (page 39)
R
You can hold the previous zoom setting (feature #468
on page 65).
R
When using the scanner glass,
the unit will only
enlarge the right top corner of the document starting
from the mark on the unit.
R
When using the automatic document feeder,
the
unit will only enlarge the centre of the upper part of
the document. To make an enlarged copy of the
bottom of the document, turn the document around,
and then make a copy (KX-MB2010/KX-MB2025/
KX-MB2030 only).
35
5. Copier
