4.
Connect to the network.
•
Connect a switching hub to the LAN jack on the
back of the unit using a category 5 or greater
LAN cable (
F
).
Note
•
Set the switching hub to Auto Negotiation
mode.
•
If the system is set to 100M Full Duplex, it
is necessary to change the system setting
(Page 38).
•
Do not connect to a switching hub set to Half
Duplex.
•
For more details about switching hubs, refer
to the documentation for the switching
hubs.
5.
Connect the power cord to the AC adaptor.
•
Use only the power cord included with the unit.
6.
Insert the AC adaptor’s DC cord (
G
) into the DC IN
terminal on the back of the unit.
•
Use only the AC adaptor included with the unit.
7.
Plug in the power cord into the power outlet.
•
Choose an outlet that is convenient for
plugging/unplugging.
System Layout Examples
Display and Main Video Camera
Place the display and main video camera at the same
side of the room.
Note
•
If you use speakers, refer to "Amplifier/Active
Speaker Connection" (Page 25).
Digital Boundary Microphones (KX-VC600
only)
Up to 4 Digital Boundary Microphones can be
connected in cascade. There are no separate terminals
for input and output on the Boundary Microphones.
Also, an Analogue Boundary Microphone and
general-purpose microphones can be used
simultaneously.
Note
•
Make sure that the microphones are placed at
least 1 m away from the display and speakers.
Installation Manual
21
5 Connection and Preparation
Summary of Contents for KX-VC300CN
Page 63: ...Installation Manual 63 Notes ...