Other settings
Message indicator
The message indicator is located on the back
of the handset and informs you of the
following status with its flashing.
Indicator
Status
Flashing
rapidly
– Incoming call or intercom
call are now being
received. (page 14,16 )
– An alarm sounds.
Flashing
slowly
– There are missed calls.
*1 To activate, setting of message indicator
must be “On”. (page 13)
Setting the message indicator
The message indicator for the following
feature must be “On”.
–
“
Missed Call
”
(Default: Off)
1
M
N#278
2
M N
R
“ ” is displayed next to the selected
feature.
R
To cancel a selected feature, press
M N
again. “ ” disappears.
3
M
OK
N
a
M
N
Note:
R
If the message indicator flashes when the
handset is not placed on the base unit,
battery consumption is faster than usual.
Eco mode setting
You can select the desired eco mode setting
by pressing
M
R/ECO
N
.
The following settings are available for eco
mode.
–
“
Eco
”
: Reduces the base unit transmission
power by up to 90 % in standby mode.
When this setting is selected,
is
displayed on the handset display instead of
.
–
“
Eco Off
”
(default setting): Turns off eco
mode.
When this setting is selected,
is not
displayed in the handset display.
Note:
R
When there is another cordless phone in
use nearby, the base unit transmission
power may not be reduced.
R
When eco mode is active, the range of the
base unit is reduced in standby mode.
R
If you set repeater mode to
“
On
”
(page 27):
– Eco mode is disabled.
–
“
Eco Mode
”
is not displayed in the
display menu (page 20).
Dialling mode
If you cannot make calls, change this setting
according to your telephone line service. The
default setting is
“
Tone
”
.
“
Tone
”
: For tone dial service.
“
Pulse
”
: For rotary/pulse dial service.
1
M
N#120
2
MbN
: Select the desired setting.
a
M
OK
N
a
M
N
13
Getting Started
