2
MbN
:
“
Yes
”
a
M
SELECT
N
R
When the cellular phone is unpaired,
the CELL indicator is turned off.
3
M
OFF
N
Link to cell settings
Selecting which unit receives
cellular calls
You can select which unit rings and receives
calls for a cellular line. When
“
All
”
is
selected, all handsets and the base unit ring.
Handset
1
For CELL 1:
M
MENU
N#6271
For CELL 2:
M
MENU
N#6272
2
MbN
: Select the desired handset or
“
All
”
.
a
M
SAVE
N
a
M
OFF
N
Note:
R
When you select a specific handset to
receive calls for a cellular line:
– other handsets cannot answer the calls.
– the base unit can answer the calls even
though it does not ring. However, you
can make the base unit ring by adjusting
the base unit ringer volume (page 60).
R
When you change to
“
All
”
from another
setting, the base unit ringer volume also
returns to the lowest level even if the ringer
volume was changed.
R
The units selected with this setting have the
alert feature (page 72) applied to them.
Ring as cell mode
Once this feature is turned on, the handset
and base unit ring using the same ringer tone
as your cellular phone.
The following settings are available:
–
“
Off
”
: Turn this feature off to use the
ringer tones of the handset and base unit.
Caller information is announced depending
on the Talking Caller ID setting (page 56,
60).
–
“
On (with Talking CID)
”
(default):
The handset and base unit use your cellular
phone’s ringer tone. Caller information is
announced even if the Talking Caller ID is
turned off.
–
“
On (without Talking CID)
”
: The
handset and base unit use your cellular
phone’s ringer tone. Caller information is
not announced even if the Talking Caller ID
is turned on.
Important:
R
To use this feature, your cellular phone
must support Bluetooth in-band ringtone.
Refer to your cellular phone’s operating
instructions.
Handset
1
For CELL 1:
M
MENU
N#6141
For CELL 2:
M
MENU
N#6142
2
MbN
: Select the desired setting.
a
M
SAVE
N
a
M
OFF
N
Note:
R
The units use the preset ringer tones
instead of your cellular phone’s ringer tone
when a cellular call is being received if:
– your cellular phone is in silent mode
(depending on your cellular phone).
– the base unit is in use.
– 2 handsets are sharing a landline call.
– answer by voice command feature is
turned on (page 35).
R
If your cellular phone is in silent mode with
“
On (with Talking CID)
”
set, the unit
announces caller information even when
Talking Caller ID is turned off (page 56,
60).
R
When ring as cell mode is set to on, the
ringer volume depends on the cellular
phone Bluetooth output level specification.
If the ringer volume in this mode is low, turn
this feature off to use the ringer tones of the
handset and base unit.
To use the handset ringer tone
instead of your cellular phone’s
ringer tone
Select
“
Off
”
in step 2, “Ring as cell mode”,
page 21.
To change the handset ringer tone for a
cellular line, see page 54.
For assistance, please visit http://shop.panasonic.com/support
21
Link to Cell
KX-TGF97xUSA(en-us)_0928_ver121.pdf 21
9/28/2022 11:24:39 AM
